DNS Servers and Active Directory

This is where You can set the DNS Servers.  When using an Active Directory server for DNS, you must set the DNS server to that of the AD server you are attempting to get DNS from.

Secondly, you will also need to set the host name of the SimpleWAN to that of the AD. This can also be done from this page.

Third, make sure that the DNS Override remains in Disabled State.

Finally, wait for the unit to Sync under Site Overview.

If the unit does not sync, it may be ideal to reboot the device to force the changes into the unit.

• Related Articles

• When a customer wants to add their own DNS

  We would have some customers asking to add their own DNS server. This guide will give you some checklist to follow through. You need to go to General Settings to go to DNS setup landing page. On the upper right part of the General Settings landing ...

• Can I set up Reverse DNS on the Network using SimpleWAN?

  Yes, you can accomplish this by setting up the DNS Override.  Bi-Directional DNS entries can be done through the DNS override. The image above shows Unifi Cloud Controller Enabled. For those that do not have this option, you may need to enable the ...

• General Settings

  Basic Settings  Here you can set below details related to your Firewall: Host name - The first part of the Router's Domain Name (eg. 'myrouter) Domain name -  The last part of the Router's Domain Name (eg. example.com) DNS Forwarding  Custom VoIP ...

• UniFi Controller

  The UniFi Controller is a dashboard add on that will allow you to connect and manage any UniFi access point connected to your SimpleWAN network. The setup of the device is fairly simple and you should be able to get the AP online within 10-15 ...

• OPT Port Failover

  Your SimpleWAN device supports failover to a secondary connection in the event your primary connection has an issue. You can easily add this feature by contacting your Reseller/support agent and asking them to activate the feature as it needs to be ...